AprintaPro Printertilbehør

PrintaGlue is a universal superglue that has been chosen to work with a wide variety of 3D printing materials. It combines strength, quality, and durability for perfect results.

It is always good to have Superglue in next to your 3D printer, as you never know when you will need a quick repair. PrintaGlue comes in easily portable 10g bottles, which last for many secure connections.

Instructions
The contact surfaces should be dry and free of contamination like oil or grease. Apply the adhesive sparingly to one surface. Press together immediately. Hold in place for 15 to 30seconds until bond sets. Let product rest for a while to give the glue time to fully harden. After 24h the bond has been fully set.

The sharp flexible needle makes loosen clogged residue easy and effortless. The all-metal quality build was specially chosen to withstand the heat of the nozzle and to be safe from melting plastic.

Needle Method
To remove a clog with the needle method an acupuncture or hypodermic needle is required. The size of the needle needs to be small enough to fit the nozzle. For a standard diameter of 0.4mm, the 0.3mm needle works perfect.

Preheat the nozzle to the regular printing temperature for the material last in use. Be careful, the nozzle is hot and the all-metal construction of the needle conducts heat well.

The goal is to break the blockage and clear the nozzle. Insert the needle from below and carefully move it around. Then remove the needle and insert filament manually from above and & push through.

If the blockage is not yet clear repeat the steps. If this method does not work an alternative is the cold pull method.

Remove residue and clean your build plate with ease. PrintaClean is a powerful solvent to remove dust, dirt and adhesive residue from the 3D printer build plate.

Instruction
Remove the build plate from the 3D printer. The build plate should be at room temperature and without damages. Spray a generous amount of PrintaClean on the build plate. Allow the solution around 30 seconds to disolve any residue Wipe off the solution with a kitchen towel.

PrintaFix is the solution against warping. With its powerful formula, it keeps the 3D print fixated on the build plate until your model has finished.

PrintaFix works with all standard materials and every model size, from small and delicate to big and tough. The application is finished in seconds. Just Shake & Spray an even film. A bottle of PrintaFix 100ml lasts on average for up to 150 3D prints.

During the printing process PrintaFix bonds to the build plate and the print material to enable a secure connection. PrintaFix works great for PLA, PET-G, PLA or PET-G based filaments like WOOD filled or Carbon fiber filled filaments. After the print has finished, let it cool and lift to release.